Automotive Manual PDF

Set up truck on a two post lift or jack stands and remove the wheel. Then remove: 1. Upper ball joint nut 2.Tie rod nut 3 Sway bar nut Support the weight of the spindle so that tension is not placed on the ABS wir- ing or brake line. A hammer may be needed to break the ball joint and tie rod free - always wear safety goggles when using a hammer. Remove the drive axle bolts (on 4wd models). The drive axle uses a 12mm twelve point bolt; make sure you use the correct tool. FAILURE TO REMOVE THE DRIVE AXLE WILL MAKE IT VERY DIFFICULT
(more…)

[Read more →]

I installed a set of Super Pro bushings in my 1980 Volvo 244, using suspension components from mixed donor cars: some were from a 1977 242 DL, some were from a 1979 242 GT, and some were from a 1984 245 DL. Though these vehicles are very different, installation should be typical since none of them used parts specific to that model.
(more…)

[Read more →]