The Flip tarp is designed and pre-assembled for a drivers side mount, however it can also be mounted on the passenger side by applying some simple modifications. FOR A DRIVERS SIDE MOUNT SKIP TO STEP II.
Modifications for a drivers side mount
a. Locate the power unit mounting plate in the motor assembly.
b. Unbolt the mounting plate and rotate 180 degrees. Re-place bolts.
c. Unbolt the actuator and rotate it until the valves are one bolt pattern off vertical, pointing down and towards the power pack. Re-place bolts. (task is best accomplished with 2 people, one holds the actuator which weighs approx. 50 lbs, and the other removes and places the bolts.)
d. Unbolt the Sun Hydraulic Counterbalance Valve and rotate it 180 degrees. Re-place bolts.
(more…)
Flip Tarp Assembly Instructions
September 17th, 2009 · No Comments
Ford 5.0 Bellhousing Installation Instructions
June 27th, 2009 · No Comments
This bellhousing is designed to fit all 1965 and up 289, 302, and 351 W/C engines. You may use a 164 or 157 tooth flexplate. These are available from ATI in heavy duty and SFI versions with any weight configuration. This bellhousing can not be used with a 12″ diameter torque converter, but it can be used with 7, 8, 9, 10 or 11″ units. The torque converter bolt pattern must match your flexplate pattern.
(more…)
