Automotive Manual PDF

1. Raise vehicle and support with jackstands on a stable surface.
Note: Vehicle must be supported with vehicle’s normal weight on rear axle. Do not support vehicle by its trailing arms.
2. Remove only one of the stock lower trailing arms.
3. Install the Edelbrock lower trailing arms with the spherical ball at the rear axle mounting point and the grease fitting on top of the arm. It may be necessary to spread the rear end mounting tabs slightly to install trailing arm.
(more…)

[Read more →]

The front control arm mounting pockets must be trimmed slightly to install the front crossmember (0 902). Make a cut mark along the front lower bottom edge of the pocket to be flush to the control arm mounting surface. Also, make a mark in line with the inside lower edge to remove the rounded corner from the lower plate (Fig 22). Cut the marked area of the control arm pocket and paint any bare metal to prevent corrosion.
(more…)

[Read more →]