Automotive Manual PDF

STEP 1. Remove the contents from box and check for damage. Verify all parts are present. Read instructions completely before beginning
STEP 2. Determine passenger and driver uprights and center section assembly and assemble as shown. Hand tighten all fasteners centered in slots or holes. Be sure dimple in ring mount plate is to the top.
STEP 3. For easier installation, it may be necessary to remove grille from vehicle but it’s not necessary on all models. Remove plastic shroud to gain access to grille by removing seven plastic pin retainers. Pull center pin up with a small flat tip screwdriver. Remove 6mm bolt from top of grille. Pull on outer edge of grille by applying firm pressure away from the fender, repeat on the opposite side and center section. Carefully remove grille from vehicle.
(more…)

[Read more →]

1. Remove the factory grille shell from vehicle, by releasing the (4) key hole tabs across the top of grille shell. Then there are (2) clips behind the parking lights on the driver & passenger side of grille shell, release by pulling straight out on shell. Then release (3) clips along the bottom of grille shell, by pulling straight out on shell.
2. After grille shell is removed place shell face up on a protective surface, such as a blanket or rubber mat.
Next you will be removing the center section of the factory grille shell, using a cut-off wheel or hack saw. Trim all vertical & horizontal plastic holding center in place.
(more…)

[Read more →]