Attaching the filter mount
1. Survey the engine compartment for possible mounting locations. Solid structures such as the firewall, fender well, radiator support or frame are normal locations. (Do not mount on engine.) Refer to diagram B for minimum area requirements and consider accessibility for servicing.
2. Refer to diagram A for preferred mounting positions.
3. When the location has been determined, use the mounting template provided to locate and mark mounting holes. This can be easily done with a center punch and hammer.
(more…)
Spin-On By-Pass Filter Installation and Servicing Instructions
August 18th, 2009 · No Comments
BMK-21 Single Mount By-Pass Filter System Installation and Servicing Instructions
July 31st, 2009 · No Comments
This filter system is not designed to replace the engine’s normal full-flow filter. Do not attempt to install a by-pass filter element in place of the existing full-flow filter.
WARNING: Extreme care should be taken to avoid bodily harm during installation. Before starting, ensure the engine is cool to avoid burns and never work in the engine compartment area with the engine running.
(more…)
2005-2006 Jeep Grand Cherokee/Commander 4″ Suspension System
July 26th, 2008 · No Comments
The front control arm mounting pockets must be trimmed slightly to install the front crossmember (0 902). Make a cut mark along the front lower bottom edge of the pocket to be flush to the control arm mounting surface. Also, make a mark in line with the inside lower edge to remove the rounded corner from the lower plate (Fig 22). Cut the marked area of the control arm pocket and paint any bare metal to prevent corrosion.
(more…)
