Automotive Manual PDF

Removal of the Stock Air Intake System
a) Loosen the clamp around the throttle body using a 5.5mm socket or screwdriver. Pull the Intake Air Temperature (IAT) sensor out of the intake tube by loosening the spring loaded clamp.
b) Unplug the breather tube from the fitting underneath the intake manifold.
c) Remove the air box mounting bolt shown in the picture.
d) Remove the other air box mounting shown in the picture.
e) Carefully remove the air box assembly from the engine bay.
f) Remove the two fasteners holding the plastic cover in front of the battery.
(more…)

[Read more →]

Thank you for purchasing Granatelli Signature Series cold air induction system. Like all Granatelli Motor Sports products, great pride and precision craftsmanship went into making these parts.
1. Disconnect your negative battery cable
2. Sliding the red safety tab backward, unplug your factory mass airflow sensor. Depress the black and slide the connector from the sensor itself.
3. Remove the breather tube from both the stock air intake and the valve cover; you will no longer be using this piece.
4. Remove the 10mm bolt holding the stock air box to the inner fender. Be sure to keep track of this bolt, you will be reusing it later (step 7).
(more…)

[Read more →]

While this kit is an easy bolt-on system, Rize Industries, LLC. strongly recommends that a professional installation center be contracted to do the install. Rize Industries, LLC. also recommends using a hydraulic lift when performing this installation.
(more…)

[Read more →]

This air intake kit requires re-calibration of the factory engine management software. If you do not have a way to re-calibrate the engine control module (ECM), do not install this system until you are able to do so.
• Disconnect battery ground.
• Remove gray retaining clip on the bottom side of the MAF sensor, then disconnect MAF sensor connector.
• Disconnect breather tube from bellows.
(more…)

[Read more →]