Step 1: Install Bulkhead Adapter
A. Remove the forward upper Tie Down Brackets.
B. Remove the two (2) upper Bedrail bolts per side.
C. Remove the three (3) upper Bulkhead bolts.
Step 2: Installing Mounting Flanges on Bedrails and Bulkhead
Note: Notice that two sizes of metric bolts have been provided. The four (4) large 8mm x 40mm bolts are to be used in the forward positions of the Track Mounting Flanges where the tiedown brackets were removed. The seven (7) smaller 6mm x 40mm bolts are to be used in all the other locations.
(more…)
[Read more →]
September 29th, 2009 · No Comments
This truck bed cover is designed for trucks that DO NOT have a bed liner. Trucks that DO have a bed liner may require some minor trimming or modification of the bed liner to insure proper placement for the brackets. Trimming or modification will vary between different brands of bed liners and model of your truck. Remember: Any modifications must be made to the bed liner and NOT to the installation hardware. Modifications to the installation hardware will result in a improper installation and will void your warranty. (See page 9 for do’s & don’ts regarding bed liners.
(more…)
[Read more →]
September 14th, 2009 · No Comments
GUARDIAN MODULE - Remove the lower dash panel below the steering column. The Guardian Module should be positioned in a secure area below the steering column. It can be secured using self tapping screws, adhesive foam tape, or wire ties. Do not secure the module until all harnesses are installed and proper lift operation has been verified.
(more…)
[Read more →]
Position the compact alarms and the sirens in the engine compartment, on the support of the passenger’s side shock absorber. Pass the cables through the original core hitch located in the bulkhead that divides the engine compartment and the passenger’s compartment, passenger’s side.
(more…)
[Read more →]
