Automotive Manual PDF

Step One
REMOVE CANISTER PURGE VALVE BRACKET AND ROCK RAIL
Remove the Canister Purge Valve Bracket from the Rock Rail. Set the bolt aside to be reused later. Then remove the ten bolts that secure the Rock Rail to the vehicle. Set these bolts aside also. Some of them will be used again later
Step Two
INSTALL NEW CANISTER PURGE VALVE BRACKET
Locate the 4th set of holes from the front on the inner sill. Place the Canister Purge Valve Bracket from the Parts Kit over the holes and install it with the bolt that was removed in Step One. Install the Canister Purge Valve on the bracket using an M8 x 20 Bolt, Nut and Washer.
(more…)

[Read more →]

PREPARATION
1. Remove the EVAP hose, brake booster hose, PCV hose, vacuum hose, water bypass hoses, throttle cable, fuel lines, fuel injector connectors, IAC valve connector, TP sensor connector, MAP sensor connector, and EVAP canister purge valve connector from your current intake manifold and throttle body setup.
2. Remove the throttle body.
3. Remove the intake manifold brackets, intake manifold, and intake manifold gasket.
If adapting an Accord Euro R or 06 Civic Si intake manifold onto an 02-06 RSX/ITR or 02-05 Civic Si/CTR style head, continue to follow the remaining “PREPARATION” steps, otherwise skip to “INSTALLATION”
(more…)

[Read more →]

Due to vehicle-build variations the Power Step may not correctly align with vehicle cladding. Using supplied shims, please follow the instructions be- low to correct the alignment. Remove canister purge valve bracket from rock rail remove existing rock rail by unscrewing ten bolts Install new canister purge valve bracket on fourth set of holes from the front (upper bolt)
(more…)

[Read more →]