To get the most life and performance from RaceTEX bulk muffler packing, a mu ffler should be repacked with the core in it. Ideally, you would like to fill the front of the muffler first (the end closest to the engine) and work towards the exit. This isn’t always possible as with mufflers that have cores welded to the rear end-cap (Honda CRF150R, White Brothers E-Series for example).
(more…)
Bulk Instructions Simple
December 5th, 2009 · No Comments
1999-2004 Honda Odyssey Bracketron Phone Mount Installation Intructions
December 2nd, 2009 · No Comments
Remove the bezel that surrounds the climate control and extends behind the transmission shifter. To do this, grasp the bezel behind the shifter and release the first clip. In the upper-right corner of the bezel, use the Dash Trim tool to work loose the remaining ten (10) clips that hold the bezel in place. Note: On vehicles without the navigation system and/or with the DVD, the climate controls will come off with the bezel. Note: On vehicles that have the navigation system, disconnect the emergency light switch connector, and interior lighting switch. Apply the emergency brake and turn the ignition to the on position. Place the transmission shifter into the neutral position. Pull the shifter lever toward you to allow clearance for the bezel to be removed. Place the bezel aside when removed.
(more…)
07-09 GMC Sierra 2500\Chevy Silverado 2500 Bull Bar Installation Instructions
September 12th, 2009 · No Comments
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. NOTE: It may be necessary to remove/relocate front license plate and license plate bracket. It is not required, but strongly recommended. If local/state law requires a license plate, license plate relocation kit is available.
3. From underside of vehicle, remove the two bolts holding the driver factory tow hook, then remove tow hook from vehicle. NOTE: This Bull Bar is not compatible with factory tow hooks, so you will not be reinstalling factory tow hooks back onto vehicle.
(more…)
1997-2000 F250 Light Duty Pickup Bracketron Phone Mount Installation Instructions
July 23rd, 2009 · No Comments
When installing in a vehicle with an Auto Climate Control you will not be drilling or using the included screws. See step (3). When re-installing the auto climate control unit in the cavity you will need to apply some downward pressure on the unit so the centering pins and four factory screw holes will line up. Install the four (4) screws that secure the auto climate control then tighten. The mount will be nice and tight.
(more…)
Bracketron Phone Mount Installation Instructions
July 15th, 2009 · No Comments
This kits support for following vehicles:
MERCURY MOUNTAINEER (1996-2001)
FORD RANGER (1995-2007) FORD EXPLORER (1995-2001)
MAZDA B2300 (1995-2007), MAZDA B2500 (1998-2001)
MAZDA B3000, B4000 PICKUP (1995-2007)
FORD SPORT TRAK (2001-2005)
NOTE: READ INSTRUCTIONS COMPLETELY BEFORE INSTALLING THIS BRACKETRON PHONE MOUNT.
All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever your removing or handling plastic parts of a vehicles dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break.
(more…)
1995-2007 Ford Ranger - 1995-2001 Ford Explorer Mercury Mountainer Installation
May 28th, 2009 · No Comments
Locate four small holes on the face of the radio. Insert the (Ford Radio Removal DIN Tools) into these holes until you hear and feel a light click. Press outward on the DIN tools while at the same time pulling on them to slide the radio out of its cavity. Disconnect any wiring to the radio and set it aside in a safe place.
(more…)
