The AEM air bypass valve is ONLY compatible with genuine AEM intake systems. You must ensure that the valve is installed in the correct location for your vehicle and that the rubber soft mount that was originally supplied with the AEM intake is properly installed. The structural integrity of the valve depends on correct installation. Use of the AEM Air Bypass Valve in conjunction with any other system is neither recommended nor warranted and may result in, among other things, malfunction of the AEM Air Bypass Valve.
(more…)
Air ByPass Valve Installation Instructions: 20-400s, 20-401s, 20-402s & 20-403s
March 12th, 2010 · No Comments
2005-07 Ford Mustang Cold Air Induction System Installation Instructions
April 20th, 2009 · No Comments
Thank you for purchasing Granatelli Signature Series cold air induction system. Like all Granatelli Motor Sports products, great pride and precision craftsmanship went into making these parts.
1. Disconnect your negative battery cable
2. Sliding the red safety tab backward, unplug your factory mass airflow sensor. Depress the black and slide the connector from the sensor itself.
3. Remove the breather tube from both the stock air intake and the valve cover; you will no longer be using this piece.
4. Remove the 10mm bolt holding the stock air box to the inner fender. Be sure to keep track of this bolt, you will be reusing it later (step 7).
(more…)
2005-2009 Ford Mustang V-6/GT Cold Air Induction System
March 16th, 2009 · No Comments
Included in this kit: Inlet pipe, coupler hose, hose clamps, air filter, air filter shield, and rubber sealant strip. (2) M-4 screws.
Tools required: Small flat screwdriver or pick, 1/4″ ratchet, 8mm, and 10mm sockets, 2.5mm Allen wrench, T-20 Torx.
Step 1
Disconnect (–) negative battery terminal.
Step 2
Unplug the mass air meter by sliding the red colored locking clip back, and then squeezing the tab on the connector while pulling it from the mass air meter.
(more…)
