Tools Needed: 10, 12, 14 sockets and wrenches. You will also need a Oxygen Sensor removal tool or 22mm wrench or socket to remove the stock Oxygen sensors from the catalytic converter and install them in the new Jackson Racing header. Most of these tools are available at your local hardware or auto parts store.
IF YOU ARE NOT A COMPETENT MECHANIC, DO NOT ATTEMPT THIS INSTALLATION! ALLOW AT LEAST ONE HOUR FOR THE EXHAUST SYSTEM TO COOLBEFORE DOING ANY EXHAUST SYSTEM INSTALLATION WORK.
READ THESE INSTRUCTIONS THOROUGHLY! Follow the instruction STEP-BY-STEP, and your installation will be trouble free. If in doubt, CALL!
(more…)
[Read more →]
Before proceeding with the installation, it is important to know that to validate the 2 year, 100K warranty on your new JR supercharger, you must completely fill out the Moss Motors / Jackson Racing warranty card that comes in every kit, including serial number which is on a small white ‘bar code’ label on the body of the supercharger. Write down all of the numbers which appear on that label in the appropriate space on the warranty card. Be certain to do this now because once your supercharger is installed, it may be almost impossible to retrieve that serial number.
(more…)
[Read more →]
The KraftWerks Honda Fit Injector Upgrade kit is designed to be used in conjunction with the KraftWerks Fit Base Supercharger Systems. If you are a competent mechanic with a good set of tools, the installation will be relatively simple. This is a general installation guide for the KraftWerks Fit Injector Upgrade kit; however each installation may vary slightly. Please keep these key factors in mind before installing:
Please review the entire installation guide before attempting install. If you have any questions about your ability to perform this installation, we recommend you take your vehicle to a performance shop for installation.
(more…)
[Read more →]
September 10th, 2008 · No Comments
Whilst the fitment of this assembly is not difficult, it should be approached with care and by a competent mechanic or automotive technician. These instructions are a guide only, and may be altered or reviewed at any time. If you find a more convenient fitment process, we would gladly like your input. This document is offered only as a guide, and no liability (direct or consequential) is implied or accepted by Harrop Engineering. We gratefully acknowledge Holden for allowing us to use the images shown below.
(more…)
[Read more →]
