Automotive Manual PDF

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temperature sensor electrical connection as shown.
3. Unclip the battery cable from the air inlet duct as shown.
4. Loosen and remove the two bolts that secure the air inlet duct as shown.
5. Remove the air inlet duct.
6. Loosen and remove the four bolts that secure the air intake resonator.
(more…)

[Read more →]

The overdrive cable assembly must be cut to a specified length depending on the vehicle application. The chart at the top displays the correct cable casing lengths for specific Ford vehicles. Length of cable casing (From shoulder of threaded fitting to end of casing.) Allow 5″ of wire beyond trimmed casing The cable casing length is determined by the illustration above. It is recommended to allow an additional 5″ of wire to extend beyond the trimmed cable casing while the handle assembly is completely pushed in.
(more…)

[Read more →]

Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body intake cover.
3. Remove air intake hose assembly.
4. Remove (4) bolts from the throttle body.
5. Remove throttle linkage bracket and save screws. (Ref. “B” & “C”)
(more…)

[Read more →]