Automotive Manual PDF

Installation Instructions
1. After bike is cool make sure the bike is secured before beginning the installation.
2. Remove the right side fairing (refer to the owners manual for more information on removal).
3. Remove the stock exhaust from the bike. Unbolt the exhaust mount on the rear peg and loosen the collector clamp and remove the stock system.
4. Attach the LOR exhaust canister to the slip-on tube adapter with the spring tabs aligned (make sure your hands are protected with a pair of gloves in case the tubes slip). You may have to squeeze the mid-pipe adapter tube to fit into the exhaust inlet as the mandrel bends may become slightly out of round due to a cut near the bend (the tube will take form once connected). Slide the canister all the way until the slip-on adapter seats fully against the exhaust inlet. Wipe off any excess silicone.
(more…)

[Read more →]

The vehicle must be turned off and the keys MUST NOT be in the ignition during the entire installation. We recommend that you place the keys in your pocket while installing the module. Failure to follow this suggestion may result in damage to your PCM.

Removal of PCM
Begin by disconnecting the negative battery terminal of your car’s battery. Next, locate your car’s PCM. The PCM is held in place by a 7/32” or 5.5mm bolt. Please remove this bolt. Next, remove the wiring harness by use of 10mm socket and ratchet. Slowly and gently pull the PCM out of its location and out of the car.
(more…)

[Read more →]