Automotive Manual PDF

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temperature sensor electrical connection as shown.
3. Unclip the battery cable from the air inlet duct as shown.
4. Loosen and remove the two bolts that secure the air inlet duct as shown.
5. Remove the air inlet duct.
6. Loosen and remove the four bolts that secure the air intake resonator.
(more…)

[Read more →]

Removal of Factory Intake
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unclip the six over center clamps, then remove the air cleaner lid.
3. Remove the air injection pump hose from the stock intake tube.
4. Remove the crank case vent hose from the stock intake tube.
5. Loosen the hose clamp at the throttle body, then remove the intake tube and filter.
6. Remove the solenoid from the lower air cleaner assembly.
7. Unclip the wire harness from the lower air cleaner assembly.
8. Unclip the vacuum hose from the rear of the lower air cleaner assembly.
9. Remove the three bolts that secure the lower air cleaner assembly.
10. Remove the lower air cleaner assembly.
11. Remove the stock rubber hose from the crank case vent on the cam cover and from the hard line.
(more…)

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Loosen and remove the air cleaner wing nuts, then remove the air cleaner lid.
3. Disconnect the cold inlet tube and then remove the air cleaner base assebmly as shown.
NOTE: Some vehicles are equipped with and air injection check valve which is vented to the air cleaner assembly. On these vehicles, remove the rubber hose and clamp the provided filter to the check valve.
4. Loosen and remove the two bolts that secure the air inlet/resonator, then remove the assembly as shown.
NOTE: K&N recommends that you do not discard your factory air intake.
(more…)

[Read more →]