Automotive Manual PDF

The rack must be inspected before each use to make certain attachments are secure, and for evidence of Wear. Misuse of the rackor failure to observe the manufacit/rer ’s mär action s as to installation, proper Attachment and maintenance will void any warranties that may be implied by law.
1. Plastic Bag labeled #1 remove contents and press rubber protective strip #1 on to bottom of fairing #2.
2. Plastic Bag, labeled #2 re move c ontents and place black button head sere w #3 thru blac k washe r and then thru fairing #2. Place fairing onto bracket #4 and attach black washer, lock washer and wing nut finger tight only. Attach all 4brackets but do not attach fairing to rack at this time.
(more…)

[Read more →]

1. The filter is located behind the glove compartment. Unscrew the 2 screws at the bottom of the glove box cover to loosen the it. Remove glove box and set it aside.
2. Cut the plastic cover along the dotted lines shown and remove it. Dispose off plastic cover, it is no longer needed. This exposes the metal cross bar under it. Locate and remove 2 additional bolts securing bar. Remove and set it aside.
(more…)

[Read more →]

Connect front and rear sections
Each side rail side contains a front and rear section preassembled for easier assembly. The front and rear sections are banded together. Remove the banding and separate the front and rear rail sections from packaging. On a flat surface, place boards under the front and rear rail sections as shown so that the rear ‘Y’ bracket does not touch the ground. This will make aligning the front and rear rail sections faster. On the front section (the end with the straight round tube), slide the 5” bracket backwards until the two back holes on the 5” bracket line up with the two holes on the end of the lower rectangle tube. Insert the rear rail section into the 5” bracket and line up with two remaining holes.
(more…)

[Read more →]

Refer to your Owner’s Manual for instructions on lowering and removing the canvas top. ALL hardware for your soft top should be removed. This includes the trim around the body. Some of the screws from the Canvas Top Hardware will be used in the Hardtop installation, so keep them available.
(more…)

[Read more →]