Trucks with lift kits or leveling kits installed have a higher center of gravity. Aggressive direction changes may cause a tip over. Always drive carefully and obey the speed limit.
1. FRONT SUSPENSION—remove axle nut to prevent the CV joint form coming apart.
2. Remove three nuts from under plastic plugs under hood. These attach the upper strut to the truck
3. Place rags or some other cushioning over the axle, to prevent the sharp bottom of the strut from cutting the CV boot.
4. Remove the sway bar link from the truck. This will be replaced with the sway bar link included in the kit.
5. Remove the lower bolt of the strut and remove the strut assembly. Be careful not to cut the CV boot
(more…)
Honda Ridgeline Lift Kit Instructions
November 12th, 2009 · No Comments
2009 Honda Pilot FWD/4WD ReadyLift Part# 69-8010 Installation Instructions
November 8th, 2009 · No Comments
Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground. Use a minimum 3 ton jack stands and place under frame for safety or a (2) two post lift if available. Make sure that the emergency brake is on and the rear wheels are blocked to prevent a rollout.
(more…)
