Automotive Manual PDF

Take care to follow the above diagram.
There are two leds located on the PCB, a GREEN and YELLOW. Their purpose is to aid the initial installation. A direction change is indicated with the leds. Ensure the wire pairs of the electric motors are correct (in the same direction) or the mirrors will operate opposite to each other (Match mirror connections to same connection on PCB). The unit can be triggered from any momentary normally OPEN contact (actuating trigger voltage 9V - 15V). This can be manually via a switch or electronically such as a car alarm.
(more…)

[Read more →]

In diesel vehicles it is necessary to interface with the wire that turns on the WAIT TO START light in the dash- board. This wire illuminates the bulb until the vehicle’s glow plugs are properly heated. When the light goes out the vehicle can be started. This wire is always available at the connector leading to the bulb in the dashboard. It can also be found at the Engine Control Module (ECM) in many vehicles.
(more…)

[Read more →]

Thank you for purchasing the Ford 7.3L Juice Module for the Ford Powerstroke Diesel®. The Juice module has been developed and produced from the highest quality materials available to ensure the best performance for years to come. If you have any concerns or questions, please contact us. The Ford 7.3L Juice Module is a high performance product, use at your own risk! It is strongly recommended that EGT, transmission temperature, boost gauges, or Edge Attitude monitor be installed with the use of this product.
(more…)

[Read more →]