Automotive Manual PDF

Tools needed: 8mm open end wrench or socket 7/16 socket or open end wrench 1/4×1 bolts, 5/16 flat washers and nuts
1. Using the 8mm wrench, remove the factory Air Dam.
2. Position Air Dam aligning the center hole of Air Dam with the center hole of bumper.
3. Using a bolt with flat washer on the bolt, push bolt up through Air dam into bumper.
4. Install a flat washer, and a locking nut from above. DO NOT tighten at this time.
5. Install the balance of the bolts making sure that a flat washer is against the Air Dam.
6. Once all bolts are installed, tighten starting from the center of the Air Dam working right and then center of the Air Dam working left.
(more…)

[Read more →]