Preparation for Installation
1. Make sure that there are no metal chips or other debris inside the manifold. Check that all bolts will run freely into any tapped holes.
2. Note that while this manifold makes provision for all vacuum lines and other brackets or parts that attached to the stock manifold, the vacuum ports originally on the front side of the manifold have been moved to the back for a cleaner appearance. This will require the use of longer vacuum hoses in some cases.
3. Disconnect battery and drain coolant.
4. Mark and identify all hoses and valves.
5. Check the condition of all hoses, gaskets and o-rings. Replace as needed. Use a new intake gasket. Honda #17105-P72-004.
(more…)
Acura GSR Whirlwind Intake Manifold Instructions
December 8th, 2009 · No Comments
2006 Honda Civic SI Supercharger Kit Installation Instruction
October 21st, 2009 · No Comments
Thank you for purchasing the CT Engineering Supercharger kit for the 2006 Honda Civic SI. All components have been designed and manufactured utilizing the latest in technology and materials. Please take a moment to read this instruction manual and warranty information page thoroughly before starting any work. Always work in a clean environment and use the appropriate safety equipment and tools to avoid any potential damage or injuries. CT Engineering recommends the use of a Genuine Honda Service Manual to supplement these instructions. All CT Engineering products are intended to be installed by a professional installer. Many stock parts are reused during installation. Do not damage or discard any pieces during disassembly or installation. We recommend marking any hose or wire before disconnecting to avoid confusion during reassembly.
(more…)
2003 - 2006 Chevrolet Silverado1500 & GMC Sierra 1500 Trucks Supercharger Installation
November 1st, 2008 · No Comments
1. Exercise extreme caution and common sense when working around gasoline. Extinguish all open flame or other sources of ignition and be sure to perform the following steps in an area with adequate ventilation. Personal protection in the form of eye protection and fuel resistant gloves are strongly recommended.
2. On the right (passenger) side of the intake manifold, locate the fuel pressure test port. CAUTION! The fuel in the system is under pressure! Relieve the pressure in the fuel system by depressing the check valve with a screwdriver and collecting the fuel with a shop towel.
(more…)
