Automotive Manual PDF

1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
3. Disconnect the mass air sensor electrical connection.
2. Remove the 8mm bolt that retains then engine cover onto the engine then remove the cover from vehicle.
4. Loosen the hose clamp at the throttle body.
5. Loosen the hose clamp at the mass air sensor.
6. Detach the intake tube from the throttle body and mass air sensor then remove the intake assembly.
NOTE: K&N recommends that customers do not discard factory air intake.
(more…)

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Depress the locking clip on the mass air sensor electrical connection, and then separate the mass air sensor electrical connection.
3. Loosen the hose clamp that retains the stock intake tube to the resonator, and then remove the tube from the resonator as shown.
(more…)

[Read more →]

Verifying Fit - Flares should be held to the vehicle surface to verify correct type and fit BEFORE beginning installation or painting. Small fit adjustments can be made by trimming (filing, sanding or scraping) excess plastic.
Performance - Using larger tires may increase the area required to turn the vehicle. Some Tire/Rim combinations may require lowering bump stops and/or installing steering stops to prevent tire shoulders from contacting flare.
Exhaust System - Modifications may be necessary to maintain a minimum 4 inch clearance between flares and exhaust pipes. Exhaust gases should not vent directly onto flares.
(more…)

[Read more →]

NOTE: Bushwacker only approves installing the flares according to these written instructions with the hardware provided.
WARNING: Failure to install according to these instructions will invalidate the warranty. This includes, but is not limited to using alternative installation methods, hardware, or materials. DO NOT USE: Loctite, SuperGlue, or similar products on the hardware or the flares.
(more…)

[Read more →]

Step 1:
Prior to Installation:
A) Bushwacker only approves installing the flares according to these written instructions with the hardware provided. WARNING: Failure to install according to these instructions will invalidate the warranty. This includes, but is not limited to using alternative installation methods, hardware, or materials. DO NOT USE: Loctite, SuperGlue, or similar products on the hardware or the flares.
(more…)

[Read more →]