Automotive Manual PDF

Installation
1. Slide two 5/16” dia x 1-1/8” wide U-bolts (C1) over the rear frame cross tubes as shown in figure 1.
2. Place the plow mount (A1) under the vehicle, and slide the legs of the U-bolts through the four rear holes in the plow mount. Terminate the U-bolt legs with 5/16” dia flat washers (C3) and 5/16” dia nylock nuts (C4) as shown in figure 2.
NOTE: Do not tighten the bolt and nut completely. You will do this later in the installation.
3. Slide two 5/16” dia x 1-3/8” wide U-bolts (C2) over the large side frame tubes under the vehicle and through the plow mount (A1)
(more…)

[Read more →]

Installation
1. Slide four 5/16” dia x 1-1/4” wide U-bolts (C1) over the underside frame of the ATV. If unsure of their location, position the plow mount (A1) against the underside of the ATV, just in front of the skid pan, and find the approximate location of where the U-bolts go.
2. Once the U-bolts (C1) are in place, position the plow mount (A1) under the vehicle, and slide the legs of the U-bolts through the eight holes in the plow mount. Work on one U-bolt leg at a time, as a threaded end is exposed, terminate the U-bolt leg with a 5/16” dia flat washer (C2) and 5/16” dia nylock nut (C3). Continue until each U-bolt has a washer and nut on the end of it.
NOTE: Do not tighten the bolt and nut completely. You will do this in the next step
(more…)

[Read more →]