Automotive Manual PDF

FITTING INSTRUCTIONS
Step 1 Remove the original stator & rotor.
Step 2 Fit the new rotor on to the crank shaft locating on to the key (not all models are supplied with a keyway machined into the rotor). Fit the retaining nut but don’t fully tighten if there is no keyway.
Step 3 Position the new stator over the rotor locating on the engine studs using the spacers provided and the original nuts, don’t fully tighten so that the stator can be adjusted if necessary.
Step 4 This will give a maximum total advance of about 350, this is only a guide. Engine tune will affect the actual timing for optimum performance.
(more…)

[Read more →]

Turn signal
Illuminates when the left or right turn signal or the hazard lights are turned on. If one or both of the indicators stay on continuously or flash faster, check for a burned-out turn signal bulb. Refer to Exterior bulbs in the Maintenance and care chapter.
(more…)

[Read more →]