Automotive Manual PDF

The machine can operate on any flat non resilient floor.Make sure that the machine rests solely on the three support points provided (Fig.2a). It is advisable to secure the system to the ground using the specific feet (Fig. 2a). if the machine is continually used with wheels weighing over 35 kg. The machine is supplied with a single-phase mains cable plus earth (ground). The power supply voltage (and mains frequency) is indicated on the machine identification plate and cannot be changed. Connection to the mains must always be made by expert personnel. The machine must not be set up without proper earthing.
Connection to the mains should be through a slow acting safety switch rated at 3 A (230V) or 8 A(115 V).
(more…)

[Read more →]

General safety recommendations
- The wheel balancing machine should only be used by duly authorized and trained personnel.
- The wheel balancing machine should not be used for purposes other than those described in the instruction manual.
- Under no way should the wheel balancing machine be modified except for those modifications made explicitly by the manufacturer.
(more…)

[Read more →]

1. Remove negative battery cable, then positive battery cable from the battery. If equipped, the Supplemental Restraint System will be deactivated when the battery is disconnected.
SteeRIng extenSIon
2. Remove the nut and bolt holding the steering column to the steering shaft located in the engine compartment about 8 inches down from the firewall. Mark the two shafts for realignment.
(more…)

[Read more →]