Automotive Manual PDF

Step 1
Remove the driver’s side hood cover by prying upward with both hands.
Step 2
Remove the driver’s side windshield molding. Do not peel off the rubber seal or separate from roof molding.
Step 3
Remove 4 screws from driver’s side roof railing. Remove roof and windshield molding and set it down on the table.
Step 4
Measure 1” from the beginning of the roof railing and mark on the masking tape the spot to drill ―” hole for your harness.
(more…)

[Read more →]

Do not smoke or be near open flame while performing installation. Wear eye protection as the fuel system is under pressure.
Kit includes
• Installation bracket, fuel line disconnect tool, and cable/zip ties.
• EFI multi port fuel injection hose and fuel line quick connect fittings.

Installation Procedure
• Unscrew the gas cap to release residual pressure in the fuel system.
• Locate the fuel RETURN line (smaller of the 2 lines) containing the fuel line quick connect fitting. This connection is located at the rear of the engine near the fire wall on the driver’s side. This kit is designed for mounting location of the driver’s side stud on the master brake cylinder stud.
(more…)

[Read more →]

Do not smoke or be near open flame while performing installation. Wear eye protection as the fuel system is under pressure.
Kit includes
• Installation bracket, fuel line disconnect tool, and cable/zip ties.
• EFI multi port fuel injection hose and fuel line quick connect fittings.

Installation Procedure
• Screw the 90* fittings into the top and bottom of the Fitch unit. Tighten down the lock nut on the 90* fittings.
• Using the 18” hose with the female plastic fitting, screw the opposite end to the 90* fitting at the top of the Fitch unit and the 6” male hose to the bottom of the Fitch unit.
(more…)

[Read more →]

You have just purchased the finest turbo system available for the 6.9 and 7.3 liter diesel engine. The following information will assist you in the installation of your ATS turbo system.

IMPORTANT: It is very important to read all the instructions carefully prior to any installation of your turbo system. Normal mechanical and safety procedures should be followed.
(more…)

[Read more →]