Automotive Manual PDF

1. Mounting the Air / Fuel Meter
Using the supplied Velcro, Suction Cups or L-Brackets, locate the Air /Fuel Meter in a convenient location that does not obstruct your view.
TIP: Clean the mounting area with alcohol or another nonabrasive cleaner to ensure the Velcro or Suction Cups adhere properly.
2. Disconnect the Negative Battery Cable
Locate the battery and remove the negative battery cable.
(more…)

[Read more →]

REMOVAL:
1. Engage the steering column / ignition switch lock with the steering wheel & wheels centered. (NOTE It may be necessary to remove the upper and lower steering shaft bolts prior to locking for accessibility)
2. Remove the two bolts holding the upper shaft in place. One is located in the engine compartment; the second is located under the dash at the base of the steering column.
3. Compress factory shaft assembly and remove it from under the dash. Do not spin wheel with shaft removed.
(more…)

[Read more →]

Proper operation of your brakes is essential for your safety and the safety of others. Any brake service should be performed ONLY by persons experienced in the installation and proper operation of brake systems. It is the responsibility of the person installing the component or kit for the particular application. After installation and before operating your vehicle, be sure to test the function of the brakes under controlled conditions.
(more…)

[Read more →]

The fuel pressure gauge used on the 7.3L Ford is a 0- 100 psi mechanical gauge and needs to be installed using a fuel isolator to ensure diesel fuel cannot enter the trucks interior due to a gauge or tubing failure. Install the gauge into the gauge mount with the tubing connected to the back of the gauge and fittings tightened. Pull the tubing through the firewall and near the back of the drivers side head light to the mounting location of the isolator.
(more…)

[Read more →]

1. Close any open programs make sure you have at least 700mb free.
2. Insert the VCM disk into your DVD Rom drive.
3. DVD should automatically run the disk, if not go to My Computer> and open the Purple Icon. Note: In this picture its labeled V2006.5-43, yours may be different depending on its manufacturing date.
(more…)

[Read more →]

The BC-harness is delivered complete with all the connectors. When all the wiring is complete it’s important to secure the harness and make sure that it’s not mounted directly on top of extremely hot engine parts such as the header. You can use cable ties to secure the harness.
(more…)

[Read more →]

Below you will find instructions on how to install your AC Line kit for the Acura Integra DC 94-01 Chassis.
*AC Kit may not be legal for highway use. Hybrid Racing is not responsible for any direct or indirect, actual or incidental expense attributed to the use of any performance parts sold by Hybrid Racing LLC. Purchasers agree to all of the terms of this agreement upon the purchase of parts.
(more…)

[Read more →]

There have been some changes to time allowances for engine and suspension assemblies on recently scheduled vehicles. Previous schedules have shown separate remove and replace allowances for engines and suspension assemblies of approximately 8.00 to 9.50 hours depending on make and model. When formulated, these allowances reflected a component assembly of the motor, suspension and engine compartment hardware.
(more…)

[Read more →]

1. Remove the negative battery cable first, then the positive battery cable. If equipped, the Supplemental Restraint System will be deactivated when the battery is disconnected.
2. Measure and record the space between the bumpers and the body as well as the space between the cab and bed for reference during installation of this kit.
(more…)

[Read more →]