Acura TSX Figure Grille Installation
1) PREPARATION
1.1) Remove the OEM fog light grilles, if this item was purchased. The stock fog light opening covers are held in place with spring clips attached to the cover. Work a finger between the cover and the bumper, and pull outward to release the cover.
1.2) The lower center grille is not removable; it is bonded to the bumper, and it will be left in place.
(more…)
2004-2005 Acura TSX Figure Grille Set Installation Manual
November 10th, 2008 · No Comments
Magnum’s HID H3 Fog Light Install
October 20th, 2008 · No Comments
I decided to install HID’s in place of standard halogen bulbs for a little more light and I guess exterior looks. I won’t be able to see them much so I hope you other driver’s like them. Here’s the kit, a standard 35 watt HID nothing fancy conversion kit. The only extra I bought where some load resistor to clear up any “check fog light” errors I may receive.
(more…)
Connecting the rear fog light on the A4 Jetta
August 9th, 2008 · No Comments
I’m human and make mistakes. If you spot one in this how to, tell me and I’ll fix it This was done on my 99.5 Jetta. Your car may be, and probably is different. If you do the mod and have any insights, tell me and I’ll add them. Also, if you blow up you car doing this, please don’t blame me.
(more…)
Toyota Tacoma 2005+ Service Manual
April 21st, 2008 · No Comments
This information is ONLY TO BE USED AS A GUIDE. Always consult your manual for further information. LUBRICATION Date Mileage Detail Cost Chassis Lubrication 2WD Fittings, 0 Plugs 4WD Fittings, 0 Plugs ** Synthetic multi-purpose grease NLGI #2 Clutch Fluid SAE J1703 or FMVSS No.116 DOT 3 Front Drive Shaft Thrust Bushings NLGI #1 Propeller Shaft - Spiders NLGI #2 - Slide Yokes NLGI #2 ** Synthetic multi-purpose grease TIRE PRESSURE ** Proper Tire Pressure Is Printed On Sticker ** ** Located On/Near Drivers Door Jab
(more…)
