Automotive Manual PDF

ON-BOARD PROGRAM GM Pass-Key III (Easily identified by a ‘PK3’ stamped on the blade)
ORIGINATE A NEW KEY:
1. Insert new transponder key and turn ignition to ‘ON’ position. The dashboard security light will turn on and stay on for 10 minutes.
2. Once the security light goes out, you have one minute to to begin Step 3. Turn ignition to ‘OFF’ and then back to ‘ON’ position.
3. Repeat Step 2.
4. Once the dashboard security light has turned off for the third time, the key has been successfully programmed. This is now the only key that is
programmed to the system and all previous electronic key codes have been erased.
(more…)

[Read more →]

Remove Factory Shock and Spring
Raise front end of car and secure with jack stands. Wheels must not be in contact with ground.
1. Remove wheels, making note of which side of vehicle they were removed from.
2. Unbolt lower shock mount from spring perch (Figure 3-1).
3. Unbolt upper shock mount from shock tower (Figure 3-2).
4. Remove shock and mount from vehicle (Figure 3-3).
5. Using a spring compressor, remove the coil spring. Follow the tool manufacturer’s instructions for proper use of
6. the spring compressor. Unbolt lower spring perch from control arm.
(more…)

[Read more →]

Remove Factory Shock and Spring
1. Raise front end of car and secure with jack stands. Wheels must not be in contact with ground.
2. Remove wheels, making note of which side of vehicle they were removed from.
3. Unbolt lower shock mount from spring perch.
4. Unbolt upper shock mount from shock tower.
5. Remove shock and mount from vehicle.
6. Using a spring compressor, remove the coil spring. Follow the tool manufacturer’s instructions for proper use of the spring compressor.
7. Unbolt lower spring perch from control arm.
(more…)

[Read more →]