Automotive Manual PDF

Relieving fuel pressure
a) Remove the fuel fill cap.
b) On models equipped with a 6mm service bolt. (illustrated below) If your vehicle is not equipped with a 6mm service bolt, then proceed to step c.
i) Use a box end wrench on the 6mm service bolt on top of the fuel filter or fuel rail, while holding the special banjo bolt with another wrench.
ii) Place a rag or shop towel over the 6mm service bolt.
iii) Slowly loosen the 6mm service bolt one complete turn.
iv) Leave service bolt loose until all pressure has been relieved.
v) Tighten service bolt to 10 lbf-ft.
(more…)

[Read more →]

Someone who has a basic knowledge of automobile repair and modification and is familiar with and comfortable with working on their vehicle can accomplish the mechanical installation of this kit using common tools and procedures. However, this kit is designed to allow you to custom fit the fuel lines and components to your application, and will require that you cut hoses to fit and drill holes for fuel pressure regulator mounting, junction blocks, etc. If you do not feel comfortable with any of the steps listed below, please consult a qualified professional installer. Make sure to read the instructions provided with the supplied fuel rail and fuel pressure regulator. These will be referenced throughout this instruction sheet.
(more…)

[Read more →]

Someone who has a basic knowledge of automobile repair and modification and is familiar with and comfortable with working on their vehicle can accomplish the mechanical installation of this kit using common tools and procedures. However, this kit is designed to allow you to custom fit the fuel lines and components to your application, and will require that you cut hoses to fit and drill holes for fuel pressure regulator mounting, junction blocks, etc. If you do not feel comfortable with any of the steps listed below, please consult a qualified professional installer. Make sure to read the instructions provided with the supplied fuel rail and fuel pressure regulator. These will be referenced throughout this instruction sheet.
(more…)

[Read more →]

System Components/Operation System Description Electronic Control Unit (E.C.U) Coolant Temperature Sensor Fuel Pump Air Flow Sensor Intake Air Temperature Sensor Fuel Pressure Regulator Fuel Injectors Throttle Switch Fuel Filters Oxygen Sensor Ignition System Idle Stabilization Crankcase Emission Control / Vent-Libe Heating Element Evaporative Emission System Checking / Adjusting Throttle Valve Throttle Switch (Adjusting) Throttle Switch (Wiring and E.C.U Check) Coolant Temperature Sensor Air Flow Sensor / Intake Air Temperature Sensor Fuel Injectors (Spray Pattern, Quantity)
(more…)

[Read more →]