Automotive Manual PDF

Step 1
Remove the driver’s side hood cover by prying upward with both hands.
Step 2
Remove the driver’s side windshield molding. Do not peel off the rubber seal or separate from roof molding.
Step 3
Remove 4 screws from driver’s side roof railing. Remove roof and windshield molding and set it down on the table.
Step 4
Measure 1” from the beginning of the roof railing and mark on the masking tape the spot to drill ―” hole for your harness.
(more…)

[Read more →]

This remote start product is intended for installation on vehicles equipped with automatic transmissions and electronic fuel injection only!
DO NOT INSTALL THIS UNIT INTO A MANUAL TRANSMISSION VEHICLE AS IT COULD RESULT IN SERIOUS INJURY OR DEATH.
• This product must be installed by qualified personnel according to these instructions and observing all safety features.
• The system should be placed into the valet mode when parked inside a garage or being left for service.
• Always notify service personnel that the vehicle is equipped with a Remote Starter.
• Only start the vehicle in a well ventilated area.
Do not use in a closed garage or indoors.
(more…)

[Read more →]

This system is intended for installation on vehicles equipped with automatic transmissions and electronic fuel injection only!
DO NOT INSTALL THIS SYSTEM INTO A MANUAL TRANSMISSION VEHICLE AS IT COULD RESULT IN SERIOUS INJURY OR DEATH.
• This product must be installed by qualified personnel according to these instructions and and observing all safety features.
• The system should be placed into the valet mode when parked inside a garage or being left for service.
• Always notify service personnel that the vehicle is equipped with a Remote Starter.
• Only start the vehicle in a well ventilated area. Do not use in a closed garage or indoors.
(more…)

[Read more →]