Automotive Manual PDF

RSS Feed

The Resources for Automotive

Chevrolet/GMC Silverado/Sierra Extended Cab Husky Gear Box Installation Instructions

October 27th, 2009 · No Comments

The Gear Box is designed to fit under the rear seat of your truck or SUV. The Gear Box gives you a place to store loose items and clutter and ultimately help keep your vehicle organized. It’s designed to fit your vehicle with or without your Husky Liners in place and only takes a few minutes to install.

INSTRUCTIONS
1) Open and remove the Gear Box from the shipping box and protective plastic bag.
2) Lift the rear seats into their upright position.
(more…)

[Read more →]

2003 Chevrolet/GMC 2500HD RECON 3-Piece Cab Roof Light Installation

October 10th, 2009 · No Comments

This document covers the installation of RECON Truck Accessories 3-Piece running lights on a 2003 Chevrolet/GMC Silverado/Sierra 2500 HD. RECON 3-piece Chevy/GMC Cab Roof Light Kit Boasts The Following:
Provides Maximum Visibility
Meets S.A.E. specifications
Adapts to Curved and Flat Roofs
Replaceable 194-Style Bulbs
Kit includes 2 Corner Clearance Lights and 1 Three Lamp Cluster Center Marker Light
Complete Wiring Harness with Quick Wire Connectors
Great Retail-Friendly Packaging
All Necessary Hardware
(more…)

[Read more →]

99-06 Chevy/GMC Silverado/Sierra 6.5 Bed GM-001 Armor Lid Installation Manual

September 29th, 2009 · No Comments

This truck bed cover is designed for trucks that DO NOT have a bed liner. Trucks that DO have a bed liner may require some minor trimming or modification of the bed liner to insure proper placement for the brackets. Trimming or modification will vary between different brands of bed liners and model of your truck. Remember: Any modifications must be made to the bed liner and NOT to the installation hardware. Modifications to the installation hardware will result in a improper installation and will void your warranty. (See page 9 for do’s & don’ts regarding bed liners.
(more…)

[Read more →]

Chevy/GMC Silverado/Sierra P/U 1500 4 Door Pro Step Installation Instructions

September 13th, 2009 · No Comments

Before Starting Installation
1. Carefully read all warnings and instructions completely before beginning.
2. Verify all parts have been received in this kit by checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is specified.
4. Special tools needed:
a. 17/64” & 5/16” drill bits
b. Tool to trim sheet metal
5. Park vehicle on a clean, dry, flat, level surface and block tires so vehicle cannot roll in either direction.
(more…)

[Read more →]

1999-2000 Chevrolet/GMC Silverado/Sierra 3/4 Ton 3″ Body Lift Kit

July 16th, 2008 · No Comments

1. Remove negative battery cable, then positive battery cable from the battery. If equipped, the Supplemental Restraint System will be deactivated when the battery is disconnected.
SteeRIng extenSIon
2. Remove the nut and bolt holding the steering column to the steering shaft located in the engine compartment about 8 inches down from the firewall. Mark the two shafts for realignment.
(more…)

[Read more →]