Automotive Manual PDF

RSS Feed

The Resources for Automotive

1971-1974 Cadillac Eldorado Fender Skirt Modification Kit

July 21st, 2010 · No Comments

The 1971-1974 Eldorado is a classic Cadillac that is fast becoming a collectable and appreciat
ing automobile. Sadly, even though Cadillac was a trend-setter in introducing wire wheels for their cars, the
current Eldorado owner has few choices when it comes to dressing their car up with wire wheels that add to
the elegance of the car. Roadster introduced a line of wire wheels that will work on these cars, however, due to
the very limited room in the rear wheel wells and close proximity of the fender skirt fastening hardware, the wire
wheels require that there be a few changes made to accomodate the wheels. It is our opinion that these
changes should be performed by a qualified bodyshop or fabricator so that there is no risk of harming
your car. The purpose of these instructions are to demonstrate what modifications will be involved. None of
these modifications will spoil or detract from the original appearance of your car. The modifications required are
all to areas that cannot be viewed from the outside.
(more…)

[Read more →]

Chevy/GMC Silverado/Sierra P/U 1500 4 Door Pro Step Installation Instructions

September 13th, 2009 · No Comments

Before Starting Installation
1. Carefully read all warnings and instructions completely before beginning.
2. Verify all parts have been received in this kit by checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is specified.
4. Special tools needed:
a. 17/64” & 5/16” drill bits
b. Tool to trim sheet metal
5. Park vehicle on a clean, dry, flat, level surface and block tires so vehicle cannot roll in either direction.
(more…)

[Read more →]

2005 Ford Front 6-8” Lift Kit Instructions

March 18th, 2009 · No Comments

Step 1. Before you remove anything off the truck, measure the pinion on the front and rear axle differential. Make sure to record this measurement as we will want to put each axle back to this angle after the suspension lift kit is installed. This is especially important for the front axle. Putting the front axle back to the same measurement will keep the stock camber and caster.
Step 2. Jack up the truck and place a jack stand under the frame on each side of the truck. Jack the truck up enough so that the front tires are just barely off the ground. Take a motorcycle strap and wrap the strap around the differential and to the frame. This will help keep the axle in the generalproximitywhile the factory suspension is removed and the 4 link is installed.
(more…)

[Read more →]

ACDC01 AC Line Kit for Acura Integra DC 94-01

November 11th, 2008 · No Comments

Below you will find instructions on how to install your AC Line kit for the Acura Integra DC 94-01 Chassis.
*AC Kit may not be legal for highway use. Hybrid Racing is not responsible for any direct or indirect, actual or incidental expense attributed to the use of any performance parts sold by Hybrid Racing LLC. Purchasers agree to all of the terms of this agreement upon the purchase of parts.
(more…)

[Read more →]

Honda and Acura 68mm Throttle Body

November 7th, 2008 · No Comments

Removal of Engine Accessories
1. Remove the hose clamp that holds the intake tube to the throttle body.
2. Remove the intake tube.
3. Check and measure the throttle position sensor voltage with a volt/ohm meter prior to removal. Record your voltage measurements. Disconnect the TPS.
(more…)

[Read more →]