Automotive Manual PDF

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unclip and remove the intake hose from the throttle body housing.
3. Carefully lift the air box out of the mounting grommets and remove from the vehicle.
4. Taking the necessary safety precautions raise the front of the vehicle and support it with axle stands.
5. Remove the wheel arch liner from the vehicle by removing the two screws and clips.
6. Remove the original air box intake hose from the vehicle.
7. Unbolt & remove the air box mounting bracket from the vehicle.
(more…)

[Read more →]

Tools/Supplies: Phillips screwdriver, windscreen, maybe glue
Step 1­ Remove the 2 screws just below the “HONDA” decal on the front cowl (just below the windscreen).
Step 2 ­ Remove the 2 screws on the pillars that connect the sides of the windscreen to the scooter (1 screw on each pillar, screw heads face driver)
(more…)

[Read more →]

NOTE: This kit was not designed to fit vehicles with a body lift.
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the vehicle’s air temperature sensor.
3. Loosen the hose clamp at the air intake plenum.
4. Remove the air box from the vehicle by sliding upwards.
5. Remove the air temperature sensor from the stock air intake tube.
(more…)

[Read more →]

H2 Hummer Spare Tire Carrier Mounting Instructions
1. Remove both tow loops from rear bumper with 18 MM socket.
2. Remove hinge plate from packaged swing arm assembly. To aid in positioning and support of hinge plate during installation, insert one M12 X 70MM bolt into a driver’s side tow hook mounting hole. The hinge plate can now be temporarily “hung” on the bolt (head of bolt will fit through hole in hinge plate). The hinge plate should be oriented with hinge boss towards passenger’s side (see Photo 1).
(more…)

[Read more →]