This system is a bolt-on package that is designed to enhance traction by eliminating wheel hop and promoting weight transfer to the front wheels. Installation of this product requires the permanent removal of the factory plastic splash pan located just behind the radiator support. No other modifications are required for installation.
(more…)
Honda/Acura Traction System Installation Instructions
November 9th, 2009 · No Comments
Spin-On By-Pass Filter Installation and Servicing Instructions
August 18th, 2009 · No Comments
Attaching the filter mount
1. Survey the engine compartment for possible mounting locations. Solid structures such as the firewall, fender well, radiator support or frame are normal locations. (Do not mount on engine.) Refer to diagram B for minimum area requirements and consider accessibility for servicing.
2. Refer to diagram A for preferred mounting positions.
3. When the location has been determined, use the mounting template provided to locate and mark mounting holes. This can be easily done with a center punch and hammer.
(more…)
Ford Truck Steering Shafts Installation Instructions
August 14th, 2009 · No Comments
REMOVAL:
1. Engage the steering column / ignition switch lock with the steering wheel & wheels centered. (NOTE It may be necessary to remove the upper and lower steering shaft bolts prior to locking for accessibility)
2. Remove the stock steering assembly by removing the bolts that attach it to the steering box and steering column shafts. This connection is often rusted and may require penetrating oil or a few taps with a hammer.
(more…)
Auburn Gear Differential Disassembly / Assembly Instructions
July 20th, 2009 · No Comments
These instructions are intended as an aid for the experienced automobile mechanic in properly servicing the Auburn Gear Limited-Slip differential. It is expected that the mechanic be equipped with the proper tools, equipment, and experience before attempting to service the differential. Differential removal will be required for most maintenance operations. Refer to the vehicle service manual for differential removal and installation procedures.
(more…)
2008+ Mitsubishi Lancer QuickLIFT Installation Guide
June 19th, 2008 · No Comments
Remove all items from the packing tube. You should have the following before beginning:
* (2) Gas springs (RT-QL-170-A6A) - Be sure to cycle them a few times before installing.
* (4) #2-3/16″ Multi-grip rivets (used on hood brackets)
* (2) ball-studs and washers each with a locking nut.
* (2) mounting brackets
* Printed Color Instructions
* Gas Spring locking clips - (Already installed in the gas spring ball-ends - Remove before assembly)
(more…)
