Installation Instructions:
Disconnect the negative battery cable and then disconnect the positive battery cable.
Disconnect the wiring, remove the belt, and then remove the stock alternator from it’s mounting brackets.
Mount the new alternator to the existing mounting bracket on the engine with the double feet from the alternator on either side of the mounting bracket. It is important to note that the origional alternator bracket has a “slip bushing” in it. If the Mechman alternator bracket will not slide over the bushing then it will need to be tapped back with a hammer( a very small amount of added room is needed). If extra space exist use the supplied spacers as necessary to reduce the extra space between the mounting bracket and the alternator bracket. Install the original long bolt and hand tighten. See the diagram below.
(more…)
2006-2008 Honda Civic 1.8L Large Case Conversion Alternator
November 1st, 2009 · No Comments
Install OEM HID Lights in your Mustang
April 16th, 2009 · No Comments
Be aware that this does not replace factory instructions or manuals for service work, but is a free *how-to* following the basic steps that were done on our own in-house car to make the 2008+ factory HID headlamps work on our 2005 GT that originally was not equipped with these headlights. It is worth what you’re paying for it! These instructions may or may not work on your vehicle, and we are not responsible for any damage or problems that may arise when you attempt this modification on your own vehicle.
(more…)
