The Nemesis uses both of the original multi-pin connectors to link with your bike wiring loom, no changes are necessary, but remember it is VITALLY important to re-connect the 6mm ground connector. Nemesis also re-uses the cast aluminium ‘heat sink’ from the IAW 5.9 ECU, this can be removed and re-fitted to Nemesis using a TORX T20 screwdriver without any damage to the original ECU.
(more…)
Nemesis Engine Control for Ducati
February 5th, 2009 · No Comments
VW Golf / Jetta OBD1 Chip Install Instructions pdf
June 14th, 2008 · No Comments
Please read the installation procedure listed below as it will save you time (and possibly parts) in the long run. After installation…enjoy! Caution! Be aware that E-PROM’s are static-sensitive devices, and so are the chips in your control unit. Avoid replacing chips in high static areas, and avoid touching the pins of any integrated circuit / E-PROM.
1. Open hood and remove the rubber seal laying on the top edge of the firewall. Remove the plastic raintray and locate the control unit. It is located on the driver’s side on Golf and Jetta 2 models, the passenger side on Passat and A3 models.
(more…)
