PREPARATION
1. Remove the EVAP hose, brake booster hose, PCV hose, vacuum hose, water bypass hoses, throttle cable, fuel lines, fuel injector connectors, IAC valve connector, TP sensor connector, MAP sensor connector, and EVAP canister purge valve connector from your current intake manifold and throttle body setup.
2. Remove the throttle body.
3. Remove the intake manifold brackets, intake manifold, and intake manifold gasket.
If adapting an Accord Euro R or 06 Civic Si intake manifold onto an 02-06 RSX/ITR or 02-05 Civic Si/CTR style head, continue to follow the remaining “PREPARATION” steps, otherwise skip to “INSTALLATION”
(more…)
K20A/A2/A3/Z1 Throttle Body To RBC/RRB/RBB Intake Manifold Adapter Installation Instructions
October 30th, 2009 · No Comments
Compression Mount T-Rac Instructions
July 13th, 2009 · No Comments
Installation Notes:
• The T-Rac mounts onto the side rails of your truck without drilling.
• Installation is straight forward, and should take approximately 45 minutes to complete.
1. Verify that you have received the correct parts using the assembly drawing and packing list
2. Slide 6 T-bolts into slot under crossbar (3 per side) note: the flat recess must face down
3. Attach each crossbar onto a left and right corner unit by inserting the 2 T-bolts through the saddle plate holes, and attaching locknuts. Next fasten the corner brace to the crossbar with the remaining T-bolts, washers, leaving the 3/8” self-locking nuts loose for adjustments later. Attach the bottom of the corner brace (Dimple Side) using the 3/8-16 x 1-1/4” Hex head cap screw with the Washers (Figure 2) to the corner unit.
(more…)
