Automotive Manual PDF

The HV70M may be mounted in any position (vertical, horizontal etc.). It is however recommended that a location be chosen with free airflow away from direct sources of high heat, such above exhaust manifolds or directly mounted on the engine itself. The supplied 36” high efficiency coil lead allows for remote mounting away from hot and moving engine parts. The coil lead may be shortened after installation should it be required. As well, longer coil leads, up to 72”, are available from your Aurora dealer to aid in difficult installations. Some consideration should be given to the routing of the coil lead in relation to distributor and HV70M mounting location. The coil lead must avoid moving engine parts, or surfaces that could cause abrasion. It is also strongly recommended that the coil lead avoid being bundled with any other wiring harnesses.
(more…)

[Read more →]

This product should be fitted by experienced people.
Be sure you read fitting instructions carefully and completely before fitting ute lid to vehicle.
1. Remove all packaging from ute lid.
2. With assistance - carefully place ute lid onto ute tub body, ensuring lid is sitting correctly with even gaps all around.
3. At the front of the lid, mark a line onto the tub liner on each side of both lid hinges.
4. Remove ute lid from vehicle.
5. Place the slotted hinges (1) flush with the body- between the lines you marked (2) and attach both hinges to body using self drilling screws supplied.
(more…)

[Read more →]

Congratulations on purchasing the finest hood hinge kit made. We are very proud of this kit, and you will be too! We have tried to make the installation as easy as possible. Most of the kit is pre-assembled to help you out. You will need tools, a drill, and 1/8”, 1/4”, and 3/8” bits, and a round file.

1. When the hood closes with the new hinge, it locks down with the stock hood latch. The safety latch, or secondary latch is no longer needed, so remove it.
(more…)

[Read more →]

This instruction on cam belt adjustment starts after you remove the fairing pieces. Plan on an hour to remove these. Since you are performing your own service, buying Ducati belts may not be that expensive. There may be another belt source, but I have not confirmed this for the 996 engine of the 02-03 ST4s.
(more…)

[Read more →]

H2 Hummer Spare Tire Carrier Mounting Instructions
1. Remove both tow loops from rear bumper with 18 MM socket.
2. Remove hinge plate from packaged swing arm assembly. To aid in positioning and support of hinge plate during installation, insert one M12 X 70MM bolt into a driver’s side tow hook mounting hole. The hinge plate can now be temporarily “hung” on the bolt (head of bolt will fit through hole in hinge plate). The hinge plate should be oriented with hinge boss towards passenger’s side (see Photo 1).
(more…)

[Read more →]

For older vehicles, the diagnostic connector can often be found in the engine compartment. Astra-F 16 pin OBD connector located in the fuse compartment to the right hand side of the steering wheel on RHD vehicles and to the left hand side of the steering wheel on LHD vehicles. Covering panel can be pulled off to reveal the complete fuse compartment and diagnostic connector. Astra-G 16 pin OBD connector located in the central console between the handbrake and the gearstick. There is a plastic cover that needs to be removed to find the connector. This can be done with a medium sized flat-blade screwdriver inserted at the front of the panel (nearest to the gearstick).
(more…)

[Read more →]