Automotive Manual PDF

Modifying your vehicle ride height may result in the vehicle handling differently than a factory equipped vehicle. Extreme care must be used to prevent loss of control or vehicle rollover. Failure to drive your modified vehicle safely may result in serious injury or death. ReadyLift Suspension Inc. does not recommend the combined use of suspension lifts, body lifts, or other lifting devices. You should never operate your modified vehicle under the influence of alcohol or drugs. Always drive your modified vehicle at reduced speeds to ensure your ability to control your vehicle under all driving conditions. Always wear your seat belt.
(more…)

[Read more →]

Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground. Use a minimum 3 ton jack stands and place under frame for safety or a (2) two post lift if available. Make sure that the emergency brake is on and the rear wheels are blocked to prevent a rollout.
(more…)

[Read more →]

1. Remove contents and check for damage. Verify all parts are present. Read instructions completely before installation.
2. Locate driver side mounting locations on vehicle (See Figure 1and 2). Repeat for passenger side.
3. Attach driver side front and rear mounting brackets to underside of rocker panel as shown using M8 hex bolts, 5/16” flat washer and 5/16” lock washer. Hand tighten only (See Figure 1 and 2). Repeat for passenger side.
(more…)

[Read more →]

STEP 1. Remove the contents from the box and check for any damage. Verify all parts against the parts list.
STEP 2. Read and understand instructions completely before beginning installation.
STEP 3. Determine passenger and driver brackets. SEE FIGURE 1.
STEP 4. Remove (16) push type retainers from lower splash shield. Remove plastic splash shield to gain access to mounting locations.
STEP 5. Locate bolts that hold the frame brace and bumper brackets to vehicle. Remove bolts using a 17mm and 14mm socket and ratchet.
STEP 6. Install bracket between lower radiator support and frame brace using (2) 1/2” flat washers on top of bracket’s frame brace slots and replace bolts. Install (1) 3/8-16 x 1.00” hex head bolt, (1) 3/8” lock washer and (2) 3/8” flat washers. Leave loose. SEE FIGURE 1. NOTE: It may necessary to loosen body mount bolt holding the frame brace to gain enough clearance to slide brackets in place.
(more…)

[Read more →]