Automotive Manual PDF

SECTION 1: PRE-INSTALLATION PRECAUTIONS:
Step 1: Remove the negative battery cable. Before removing the battery cable, verify that you have the “anti theft” radio code. It is usually located in your owner’s manual. If you cannot find the radio code, take your car to your local Honda dealer so that they can retrieve the code through the Honda computer network.
Step 2: Jack your car up, or put the car up in the air if you are working in a shop. Support your car with Jack Stands or Ramps if you are working on the ground. Never work under a car without some type of reliable support.
(more…)

[Read more →]

This product is to be used ONLY on the Honda S2000 and is intended to provide increased driver support when using the stock lap belt and shoulder harness. It is NOT to be used as a replacement for competition belts or at any event where 4 or 5-point restraint systems are required. This product uses an electro-magnet to activate the factory inertia-sensing mechanism built into the seat belt assembly. It does not alter the factory restraint system in any way and has no effect on the seat belt retractors or air bag system. It simply activates the “tilt” mechanism built into the seat belt, the one that normally kicks in only when you corner or brake very hard. Modifry’s Seat Belt Lock is relatively easy to install and can be quickly removed, leaving no trace it was there.
(more…)

[Read more →]

Removal of Factory Intake
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unclip the six over center clamps, then remove the air cleaner lid.
3. Remove the air injection pump hose from the stock intake tube.
4. Remove the crank case vent hose from the stock intake tube.
5. Loosen the hose clamp at the throttle body, then remove the intake tube and filter.
6. Remove the solenoid from the lower air cleaner assembly.
7. Unclip the wire harness from the lower air cleaner assembly.
8. Unclip the vacuum hose from the rear of the lower air cleaner assembly.
9. Remove the three bolts that secure the lower air cleaner assembly.
10. Remove the lower air cleaner assembly.
11. Remove the stock rubber hose from the crank case vent on the cam cover and from the hard line.
(more…)

[Read more →]

Introduction Öhlins Racing congratulates you on your choice of shock absorbers for your vehicle. Your new Öhlins high performance shock absorbers are developed from experience gained during years of successful co-operation with the World Championship winning teams. Total shock absorber length, spring travel and damping forces are developed just for your car. The design and the settings are consequently the results of extensive testing and no guesswork! All Öhlins shock absorbers are designed with just one aim; to win races.
(more…)

[Read more →]