Automotive Manual PDF

STEP 1: Adjust hood until proper alignment with matching panels is achieved.
STEP 2: Adjust primary latch until it fits into the bar on the hood. Make sure when the hood is closed you can hear the latch “click” onto the hood.
STEP 3: After you here it click, test it to be sure it’s working properly by grabbing the front edge of the hood and slowly pulling upward with a steady even pressure. If the hood opens it’s not adjusted properly; repeat STEP 2 until hood cannot be pulled open after it’s closed.
(more…)

[Read more →]

Preparation:
a) Set/Lock rear parking brake, turn gas petcock to the Off position and stand bike upright so it is sitting on the rear grab bar. Ensure bike is stable to prevent falling over during installation.

Installation:
a) One Top Slotted Hole Mount:
Press Skid Plate against the bike to temporarily hold in place.
From the bottom side install (1) #4 Washer and (1) #3 Bolt.
From the top side install (1) #2 Hook
Loosely tighten to hold skid plate in position.
(more…)

[Read more →]

Preparation:
a) Lock rear parking brake on quad, turn gas petcock to Off and stand quad upright on the rear grab bar. Make sure vehicle is secure and will not fall over while installing your new skid plate.
b) Remove OEM bolts mounting the OEM Frame Cover to the Frame using a 10mm socket wrench. You may discard the OEM mounting bolts and plastic frame cover.
(more…)

[Read more →]

INSTALLATION NOTE:
• Make sure the vehicle and the nose mask are clean and completely dry before installation. If moisture under the mask is allowed to dry, it may cloud the paint. If the mask gets wet, remove it and allow it to air-dry completely.
• Make sure any repainted surfaces are cured.
• Make sure the hood and nose of the vehicle have been waxed with a high-quality paste wax.
• Make sure you install the nose mask securely. If the nose mask starts to flap, or comes loose while driving, safely pull off the highway, stop the vehicle, and secure or remove the mask.
(more…)

[Read more →]

This product is designed to enhance the appearance of the vehicle and to shield the occupants from ordinary weather conditions. Do not rely in any way on the components of this product to contain occupants within the vehicle, or to protect against injury or death in the event of an accident. This product will not protect the occupants from falling objects. Never operate vehicle in excess of manufacturer’s specifications.
(more…)

[Read more →]

Refer to your Owner’s Manual for instructions on lowering and removing the canvas top. ALL hardware for your soft top should be removed. This includes the trim around the body. Some of the screws from the Canvas Top Hardware will be used in the Hardtop installation, so keep them available.
(more…)

[Read more →]

Since installation of this kit is beyond the control of BBR Motorsports, Inc, we cannot accept responsibility for misuse or improper installation. This kit is intended only for use on off-road motorcycles. These instructions are intended only as a supplement to the proper Kawasaki/Suzuki service manual. If the installation of this product is beyond your technical abilities please refer to a qualified service technician.
(more…)

[Read more →]