Automotive Manual PDF

Preparation:
a) Lock rear parking brake on quad, turn gas petcock to Off and stand quad upright on the rear grab bar. Make sure vehicle is secure and will not fall over while installing your new skid plate.
b) Remove OEM bolts mounting the OEM Frame Cover to the Frame using a 10mm socket wrench. You may discard the OEM mounting bolts and plastic frame cover.
(more…)

[Read more →]

1 Remove the seat.
2 Prop the fuel tank in the upright position.
3 Remove the airbox lid by disconnecting the two hooks on either side of the airbox (Fig A). Unscrew the bolts on either side of the rear of the airbox or just lift up to remove the air box.
4 Disconnect the two hoses going to the airbox
5 Remove the velocity stacks by turning them counter-clockwise and lifting up (Fig B)
(more…)

[Read more →]

Removing steering column switch
Driver’s side airbag unit and steering wheel removed.
- Pull out steering column and tilt downward as far as it will go.
- Remove screws -1-(2x). Tightening torque: 2.8 Nm (25.2 in lb)
- Remove grip - 2-.
- Remove two Phillips-head screws -arrows-. Tightening torque: 0.6 Nm (5.4 in lb)
- Remove upper steering column switch trim -1-.
When installing, insert upper section into hooks on lower section, swivel downward and secure with screws
(more…)

[Read more →]