Automotive Manual PDF

Installation Environment
1) The distance between the unit and outside wall or other goods should be kept over 200mm.The unit should be put in well-ventilated area and its temperature is within -10℃~+40 .℃
2) Check air supply pipeline of the unit and use air source with 3~10 bar to supply for the unit. When connecting the air source, please check if there is leakage in connector for air source and ensure that a certain distance between the air hose and heat source should be kept.
3) To ensure safety. Before connecting the air source, please confirm that the air pressure adjusting valve is closed. Never point the air outlet to personnel.
(more…)

[Read more →]

1. Disconnect both negative battery cables. Unlatch all four factory clips on the factory airbox.
2. Remove factory air filter by separating the inlet and outlet sections of the assembly.
3. The filter is held in place by two rubber grommets on the bottom.(Note: make sure factory grommets remain in lower air box support.)
(more…)

[Read more →]

Step 1
Set parking brake on vehicle and disconnect the negative battery terminal.
Step 2
Remove flexible inlet hose from throttle body and air box by loosening two hose clamps. Disconnect the tube to the valve cover and the inlet air temperature sensor if applicable.
Step 3
Remove plastic cover on the left side of the throttle body. Unhook the throttle cable from the throttle body link-age, disconnect the throttle position sensor and vacuum hose from throttle body.
(more…)

[Read more →]

Included in this kit: Inlet pipe, coupler hose, hose clamps, air filter, air filter shield, and rubber sealant strip. (2) M-4 screws.
Tools required: Small flat screwdriver or pick, 1/4″ ratchet, 8mm, and 10mm sockets, 2.5mm Allen wrench, T-20 Torx.
Step 1
Disconnect (–) negative battery terminal.
Step 2
Unplug the mass air meter by sliding the red colored locking clip back, and then squeezing the tab on the connector while pulling it from the mass air meter.
(more…)

[Read more →]