Automotive Manual PDF

RSS Feed

The Resources for Automotive

2010 Hyundai Genesis Coupe L4-2.0L Turbo AEM Dryflow Filter Installation Instructions

March 24th, 2010 · No Comments

1. Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect negative battery terminal.
e. Jack up the front of the vehicle and support using properly rated jack stands.
f. Do not discard stock components after removal of the factory system.
(more…)

[Read more →]

1996-00 Honda Civic EX Cold Air System Installation

November 12th, 2009 · No Comments

Getting started
a) Make sure vehicle is parked on a level surface, and set parking brake.
b) Disconnect negative battery terminal.
c) If engine has run within the past two hours let it cool down.

Removing the stock air inlet system
a) Remove the stock air box assembly and attaching hardware from inside the fender well.
b) Disconnect breather hose from the air inlet tube.
c) Disconnect air temperature sensor harness from the air inlet tube.
(more…)

[Read more →]

Turbo removal Install, Removal and Exhaust Back Pressure Valve Removal

April 4th, 2009 · No Comments

Turbocharger: REMOVAL AND INSTALLATION
Turbocharger (Removal)
1. Open the hood.
2. Remove the engine cover.
3. Disconnect the charge air cooler inlet and outlet pipes.
4. Label and disconnect the intake air heater element electrical leads, intake air temperature (IAT) sensor electrical connector, manifold absolute temperature (MAP) sensor electrical connector and the pressure hoses.
(more…)

[Read more →]

1997-2003 Ford F-150 & Expedition JLT Ram Air Intake Kit Installation Instructions

March 24th, 2009 · No Comments

Please review complete instructions prior to installing.
Step#
1 Verify you have all of the following parts included in the kit:
(1) JLT painted pipe with IAT and PCV fittings, (1) Rubber Reducer w/ clamps, (1) Rubber coupler w/clamps,
(1) S&B 4×12” Oval Air Filter, (1) MAF Adaptor with bolts, (1) Wire Harness Extension Kit,
(1) Wire Harness Extension Cover, (1) section of 3/4” hose, and (1) section of 5/8” hose
(more…)

[Read more →]

2005-2009 Ford Mustang V-6/GT Cold Air Induction System

March 16th, 2009 · No Comments

Included in this kit: Inlet pipe, coupler hose, hose clamps, air filter, air filter shield, and rubber sealant strip. (2) M-4 screws.
Tools required: Small flat screwdriver or pick, 1/4″ ratchet, 8mm, and 10mm sockets, 2.5mm Allen wrench, T-20 Torx.
Step 1
Disconnect (–) negative battery terminal.
Step 2
Unplug the mass air meter by sliding the red colored locking clip back, and then squeezing the tab on the connector while pulling it from the mass air meter.
(more…)

[Read more →]