Automotive Manual PDF

Your Honda Keyless Entry System is the product of years of research and development. It will give you many years of reliable performance, protection, and convenience. The system consists of a remote control transmitter. The remote control allows you to operate from outside the vehicle while simultaneously locking and unlocking the doors. The transmitter can also be used to intentionally activate the horn in case of an emergency. To take full advantage of your Honda Keyless Entry System, we encourage you to read this manual thoroughly.
(more…)

[Read more →]

Parts included:
- main bracket, polished, chromed
- wide cateye taillight, w/ 36” long wires (if ordered)
- fasteners: (2) ž” x ―” bolts, nuts, (4) washers for main bracket
- (2) small washers for mounting taillight to main bracket

Rear fender assembly:
- remove seat – two bolts on side
- remove seat holding metal bracket (7,22)
- disconnect rear wiring harness from wiring cluster above battery; these include rear turn signal and rear brakelight wires
- remove 2 bolts on each side of rear fender strut (9,16); this will loosen the rear fender entirely
- lift off the rear fender assembly carefully, making sure not to scratch paint !
- remove seat nut (17), and carefully separate fender (12) from metal frame (13)
(more…)

[Read more →]

Installation Instructions. Read Me!
I. DISCONNECT NEGATIVE (-) BATTERY CABLE
II. Remove Factory Intake Assembly
a) Loosen the factory hose clamps on each end of the factory intake tube assembly.
b) Using a flat head screwdriver, gently pry the radiator hose bracket from the factory intake tube assembly and remove from vehicle.
(more…)

[Read more →]

Before you begin:
Remove all components from the shipping carton.
The rack should be assembled on a padded surface such as carpet to prevent scratching of aluminum surfaces. Remove bands securing components together.
Read the instructions thoroughly to familiarize yourself with the assembly sequence.
Note that you DO NOT tighten any nuts and bolts until the completed rack is installed on the vehicle unless specified. This allows for minor adjustments to the rack during the installation process.
Gather the following tools used to assemble and install the rack.
(more…)

[Read more →]

This kit is designed to allow the installation of hydraulic roller cams in standard Ford 302 HO V8 engines originally equipped with hydraulic roller cams. In order to use this kit, your engine must have two bosses cast into the block (fig. 1) in the lifter valley area. These bosses may or may not be drilled and tapped for 1⁄4″-20 bolts. If yours are not drilled and tapped, then you must be prepared to do so during this installation process. Once you have installed your COMP Cams® Magnum Hydraulic Roller Camshaft per the camshaft installation and degreeing instructions supplied with the cam, you are ready to install the hydraulic roller lifters.
(more…)

[Read more →]

F-150 QUICK LATCH MOUNTING BRACKET INSTRUCTIONS
Step 1. Remove contents from box and check for damage. Verify all parts against parts list. Read and understand instructions completely before installation.
Step 2. Assemble brackets as shown in Figure 1.
Step 3. With lever towards the tailgate side insert lower hold-down bracket through lower hole on d-pillar.
Step 4. Insert upper hold-down bracket in upper hole of d-pillar.
(more…)

[Read more →]

Notes on fitting wide wheel and tire
• An advanced degree of mechanical skill is required to properly install this kit. If after reading these instructions you have any doubts, we strongly recommend that you have a professional install it for you. If you install the kit yourself, we recommend that you also use the applicable shop manual for your motorcycle. This kit involves significant alterations of your motorcycle and may void your factory warranty.
(more…)

[Read more →]