Automotive Manual PDF

Installation Procedure
1. Remove Stock Headlamps by removing the three flathead screws securing headlamp bezel in place. Disconnect and discard stock headlamp.
2. Notch the back side of the housing to obtain additional clearance for HID wiring harness to pass through. (Please See Fig. 1)
3. Insert the projection HID lamps into the housing and reinstall Headlamp Bezel. Ensure that the top of the HID lamp is facing up before securing in place.
4. Install the two wiring harness to vehicle with both black wires secured to a common vehicle ground and the two red wires secured to the batteries positive terminal post located on drivers side engine firewall.
(more…)

[Read more →]

Preparation
1. Ensure all lamps and accessories are OFF.
2. Ensure the ignition switch is in the OFF position.
3. Loosen the negative battery cable bolt. Remove negative battery cable from terminal and position away from battery.
4. Wait one (1) minute prior to working on the vehicle to assure SIR roof rail airbag system has been disabled for your safety. Install Camera into Endgate
(more…)

[Read more →]

Mounting the Meyer Daytime Running Lights:
1. Connect the 07104 Adapter Kit as per Nite Saber Instruction sheet (Form 1-757) Installation #4 (Installation of adapter set).
2. Turn on Vehicle and verify operations of the Vehicle Headlight, Daytime Running Lights and Snow Plow lamps. Replace and repair any defective parts, switches, etc. before installing the Daytime Running Light Module. NOTE: To test Daytime Running Light on Vehicle, make sure vehicle is outside in Daytime condition. The 99 & later Chevy is equipped with a photo sensor and will not operate under artificial light.
3. The Meyer Daytime Running Light (DRL) is mounted in the engine compartment close to the battery and near one of the front headlamps and parking lamps. When a location is found, make a mark with a pencil on the inside fender wall of the vehicle through the mounting tab of the DRL module. Drill two 1/8” holes on the marks and mount the unit with two #10 gauge screws provided.
(more…)

[Read more →]

This Suzuki Sidekick System Wiring Diagrams cover:
AIR CONDITIONING
ANTI-LOCK BRAKES
1.6L, Anti-lock Brake Circuits
1.8L, Anti-lock Brake Circuits
1.8L, Computer Data Lines
COOLING FAN
Cooling Fan Circuit
(more…)

[Read more →]

Glass mounted GSM combined antenna WARNING! On S40, V40, S60 V70 (00-) and S80 cars with inflatable curtains, the wiring must not be routed above the side windows. This would jeopardise the function of the inflatable curtain in the event of a collision

NOTE! When installing on the rear windscreen, the antenna must not be installed on the heating loops in the windscreen. However, the antenna is not affected by the area of the windscreen shaded black.
(more…)

[Read more →]