Automotive Manual PDF

Take care to follow the above diagram.
There are two leds located on the PCB, a GREEN and YELLOW. Their purpose is to aid the initial installation. A direction change is indicated with the leds. Ensure the wire pairs of the electric motors are correct (in the same direction) or the mirrors will operate opposite to each other (Match mirror connections to same connection on PCB). The unit can be triggered from any momentary normally OPEN contact (actuating trigger voltage 9V - 15V). This can be manually via a switch or electronically such as a car alarm.
(more…)

[Read more →]

1. Disconnect Battery. Do not skip this step. Also, do not try to “test” the LED array by connecting the leads directly to your battery. Permanent damage will occur to the LED array if you fail to heed these steps. Handle the LED array by the stainless steel bracket, not by the LEDs or the supporting circuitry.
2. Remove taillight lens and gasket.
3. Remove taillight bulb.
4. Remove the bulb connector from the back side of the taillight. Cut the two wires close to this connector.
5. Install the provided wire guide into the bulb hole.
6. Route the supplied electrical harness through wire guide to the area where connections will be made. Note that the ground connection (green wire) is made through the LED array’s stainless steel bracket.
(more…)

[Read more →]

Peugeot Cabriolet Owners Club articles including fixit guides Page Diagnosis of a hood fault on a 306 Operating the roof with the engine running modification Removing the rear seats Front door card removal and window adjustment Avoiding wear to the roof hydraulic hoses Checking and refilling the oil level in the hood’s hydraulic system Cleaning and re-lubricating the rear windows
(more…)

[Read more →]