Automotive Manual PDF

Upon receipt of the Rocket Locker, the casting and the light should already be assembled and wires should be fed thru casting.
Step 1: Feed wires thru hole in the oval gasket.
Step 2: Install Allen head bolts through the hole in Rocket Locker casting, plastic oval gasket, and rubber expander.
Step 3: Install threaded back plate on Allen head bolt. Snugly tighten the back plate against the rubber expander.
Step 4: Remove the tail light lens. To do this, open tailgate and remove the screws that hold the lens in place (refer to picture below). If you are not sure which screws hold the lens in place refer to your owner’s manual on how to replace tail light bulbs. Then release the tabs on the other side of the lens.
(more…)

[Read more →]

This information is ONLY TO BE USED AS A GUIDE. Always consult your manual for further information. LUBRICATION Date Mileage Detail Cost Chassis Lubrication 2WD Fittings, 0 Plugs 4WD Fittings, 0 Plugs ** Synthetic multi-purpose grease NLGI #2 Clutch Fluid SAE J1703 or FMVSS No.116 DOT 3 Front Drive Shaft Thrust Bushings NLGI #1 Propeller Shaft - Spiders NLGI #2 - Slide Yokes NLGI #2 ** Synthetic multi-purpose grease TIRE PRESSURE ** Proper Tire Pressure Is Printed On Sticker ** ** Located On/Near Drivers Door Jab
(more…)

[Read more →]