Installation Instructions
1. Figure 2 shows a cable bracket which holds a brake line to the inside of the frame rail. Loosen this bracket from the top of the frame and move the brake line down about 1/2” so that it is not interfering with hitch cross members.
2. From underneath the passenger’s side of vehicle remove or cut out the section of the heat shield that is located between the frame rails and the bed of the vehicle.
(more…)
Chevrolet/GMC 1500 Short & Long Bed 2500 Light Duty Short Bed Installation
September 15th, 2009 · No Comments
1997-1998 FORD XLT & Lariat Models Only & F-150 & Light Duty F-250 Installation
June 18th, 2009 · No Comments
1. Before beginning installation be sure to wear proper eye protection.
2. Remove the grille shell from the vehicle. Open the hood and remove the black ABS cover from grille to the radiator shroud. Remove the 8 phillips head screws on the retaining clips, lift cover up and remove the retaining clips.
3. Remove the turn signal / parking lamp assemblies by removing the 7MM head bolt at the inside corners behind each lamp. Grasp lamp and pull straight forward to remove. Lift the locking tabs on bulb socket and turn 1/4 turn CCW to remove.
(more…)
