Automotive Manual PDF

RSS Feed

The Resources for Automotive

2004 Ford E-350 Series Van 400-series Lighthead Housing Installation Guide

March 25th, 2009 · No Comments

1. Following the vehicle manufacturers instructions, remove the radiator shroud, grill, headlights and turn signals. Then remove the plastic substructure that they are mounted to (Fig. 1).
2. While holding the housing (without lighthead) in the exact mounting location, mark the location of the two mounting holes onto the mounting surface. There is a small notch cut into the inside of the two screw bosses on the housing. Use the notch as a guide, make your mark, then (with the housing removed) measure and make the mounting holes 5-3/8” apart (Figs. 2 & 3). NOTE: Depending on what lighthead you are using with this housing, you will need to drill a wire hole. Refer to the lighthead manual for the size and location.

[