Automotive Manual PDF

1. Attach the left strake to the side under spoiler using the three self-tapping screws.
2. Remove the three self-tapping screws that fasten the front inner fender to the fenderwell.
3. Remove the four clips that fasten the existing side under spoiler to the side sill, then remove the spoiler by sliding it toward the front.
4. Remove the spring nut from the end of the side under spoiler you just removed.
5. Remove the eight clips from the side sill by turning them 45 degrees.
(more…)

[Read more →]

A factory service manual is necessary to perform this installation. Do not attempt to perform this installation if you are not confident in your ability to perform all steps in the procedure, including precise drilling and tapping; consult a trained technician.
Procedure remove the stock aIr cleaner and carburetor
steP 1 Remove the seat, dash panel, and fuel tank; consult your factory service manual for specific instructions on performing this procedure.
steP 2 Remove the air cleaner assembly. Save the clamp securing the rubber manifold to the carburetor, it will be reused later. See PIC.1.
steP 3 Remove the carburetor for re-jetting; consult your factory service manual for specific instructions on removing the carburetor. Prepare the carburetor for re-jetting by removing the top cover, see PIC.2.
(more…)

[Read more →]

Check to make sure your truck does not already have some type of tail-gate assisting device installed. Some 2004 and newer trucks have factory installed torsion bars. If you have made aftermarket modifications to your truck, check to make sure they won’t interfere with installation.

STEP 1
Chevy, GMC, Dodge 1500 (year 1994-2001), Dodge 2500 (year 1994-2002) Trucks: Measure 2 3/4” above the top of the left tailgate pivot post, where the tailgate mounts (Figure 1). Ford, Dodge 1500 (year 2002-present), Dodge 2500 (year 2003-present), Nissan and Toyota Trucks: Measure 3 3/4” above the top of the left tailgate pivot post, where the tailgate mounts (Figure 1).
(more…)

[Read more →]

The lives of people depend on your proper installation and servicing of Federal products. It is important to read and follow all instructions shipped with the products. In addition, listed below are some other important safety instructions and precautions you should follow:
Before Installation
Qualifications
• To properly install an electronic siren: you must have a good understanding of automotive electrical procedures and systems, along with proficiency in the installation and service of safety warning equipment. Always refer to the vehicle’s service manuals when performing equipment installations on a vehicle.
(more…)

[Read more →]

If you still have transmission in your Samurai, chances are very good that it makes a little noise in at least one of the forward gears… You have a few choices. You can try and find a dealer money. Our kit was purchased from Petroworks.
(more…)

[Read more →]